JetHome docs/Controllers — English @ Weblate

Russian

Контроллер **JetHub E1-PD76-R5-AC (v2,v3)** предназначен для управления силовой нагрузкой в системах домашней автоматизации. Содержит пять силовых реле, шесть дискретных входов "сухой контакт" и вход для подключения датчиков 1-Wire.

1286 ../../controllers/mcu/e1/jethub_e1_pd76_r5_ac.rst:4
	Russian Микроконтроллер JetHub E1-PD76-R5-AC (v2,v3)
	English JetHub E1-PD76-R5-AC microcontroller (v2,v3) 44/440 · 44 Review state Translated
1287 ../../controllers/mcu/e1/jethub_e1_pd76_r5_ac.rst:15
	Russian Контроллер JetHub E1-PD76-R5-AC (v2,v3) предназначен для управления силовой нагрузкой в системах домашней автоматизации. Содержит пять силовых реле, шесть дискретных входов "сухой контакт" и вход для подключения датчиков 1-Wire.
	English The JetHub E1-PD76-R5-AC (v2,v3) controller is designed for controlling power loads in home automation systems. It contains five power relays, six digital dry contact inputs and a 1-Wire sensor input. 204/2320 · 232 Review state Translated
1288 ../../controllers/mcu/e1/jethub_e1_pd76_r5_ac.rst:52 • ../../controllers/mcu/e1/jethub_e1_pd76_r5_dc.rst:52
	Russian Клемма 1-Wire
	English 1-Wire terminal 15/130 · 13 Review state Translated
1289 ../../controllers/mcu/e1/jethub_e1_pd76_r5_ac.rst:53
	Russian Клемма питания 100-240В AC
	English Power supply terminal 100-240V AC 33/260 · 26 Review state Translated
1290 ../../controllers/mcu/e1/jethub_e1_pd76_r5_ac.rst:58 • ../../controllers/mcu/e1/jethub_e1_pd76_r5_dc.rst:58
	Russian Внутренняя кнопка аппаратного сброса (RESET)
	English Internal hardware reset button (RESET) 38/440 · 44 Review state Translated
1291 ../../controllers/mcu/e1/jethub_e1_pd76_r5_ac.rst:70
	Russian Контроллер JetHub E1-PD76-R5-AC (v2) комплектуется процессорным модулем E1-CPU ревизии 1.2 и периферийной платой PD76-R5 ревизии 2.0.
	English The JetHub E1-PD76-R5-AC (v2) controller is equipped with an E1-CPU revision 1.2 and a PD76-R5 peripheral board revision 2.0. 137/1450 · 145 Review state Translated
1292 ../../controllers/mcu/e1/jethub_e1_pd76_r5_ac.rst:72
	Russian Контроллер JetHub E1-PD76-R5-AC (v3) комплектуется процессорным модулем E1-CPU ревизии 1.3 и периферийной платой PD76-R5 ревизии 3.0.
	English The JetHub E1-PD76-R5-AC (v3) controller is equipped with an E1-CPU revision 1.3 and a PD76-R5 peripheral board revision 3.0. 137/1450 · 145 Review state Translated
1293 ../../controllers/mcu/e1/jethub_e1_pd76_r5_ac.rst:76
	Russian Контроллеры JetHub E1-PD76-R5-AC (v2) и JetHub E1-PD76-R5-AC (v3) функционально идентичны.
	English The JetHub E1-PD76-R5-AC (v2) and JetHub E1-PD76-R5-AC (v3) controllers are functionally identical. 107/980 · 98 Review state Translated
1294 ../../controllers/mcu/e1/jethub_e1_pd76_r5_ac.rst:78
	Russian Однако, обратите внимание, что ПО для контроллеров JetHub E1-PD76-R5-AC (v2) не будет работать на контроллерах JetHub E1-PD76-R5-AC (v3) из-за разных микросхем расширителей портов, установленных в версиях 2 и 3 данных контроллеров.
	English However, please note that software for JetHub E1-PD76-R5-AC (v2) controllers will not work on JetHub E1-PD76-R5-AC (v3) controllers due to the different port expander chips installed in versions 2 and 3 of these controllers. 240/2470 · 247 Review state Translated
1295 ../../controllers/mcu/e1/jethub_e1_pd76_r5_ac.rst:81 • ../../controllers/mcu/e1/jethub_e1_pd76_r5_dc.rst:80
	Russian Для примера смотрите описание конфигурации ESPHome в разделе "Программное обеспечение" для данных контроллеров.
	English For an example, see the ESPHome configuration description under "Software " for these controllers. 106/1190 · 119 Review state Translated
1296 ../../controllers/includes/motherboards/pd76_r5_v2/revisions.rst:9
	Russian v2.0
	English v2.0 4/100 · 4 Review state Translated
1297 ../../controllers/includes/motherboards/pd76_r5_v2/revisions.rst:11
	Russian Добавлена клемма для подключения датчиков 1-Wire. Два варианта исполнения: питание DC и AC.
	English Added terminal for connection of 1-Wire sensors. Two versions: DC and AC power supply. 86/910 · 91 Review state Translated
1298 ../../controllers/includes/motherboards/pd76_r5_v2/peripherals/onewire.rst:1
	Russian В контроллере предусмотрена возможность подключения внешних датчиков по шине `1-Wire`.
	English The controller has the capability to connect external sensors via the `1-Wire` bus. 83/860 · 86 Review state Translated
1299 ../../controllers/includes/motherboards/pd76_r5_v2/peripherals/onewire.rst:3
	Russian Шина `1-Wire` подключена к выводу ``GPIO16`` микроконтроллера ESP32.
	English The `1-Wire` bus is connected to the ``GPIO16`` ESP32 microcontroller pin. 75/680 · 68 Review state Translated
1300 ../../controllers/includes/motherboards/pd76_r5_v2/peripherals/onewire.rst:5
	Russian На плате установлен подтягивающий резистор на линию данных `1-Wire`, дополнительных внешних подтягивающих резисторов устанавливать не нужно.
	English A pull-up resistor for the `1-Wire` data line is installed on the board, so there's no need to install additional external pull-up resistors. 141/1400 · 140 Review state Translated
1301 ../../controllers/includes/motherboards/pd76_r5_v2/eeprom_at24c64.rst:2
	Russian EEPROM периферийной платы
	English EEPROM of the peripheral board 30/250 · 25 Review state Translated
1302 ../../controllers/includes/motherboards/pd76_r5_v2/eeprom_at24c64.rst:4
	Russian На периферийной плате установлена микросхема энергонезависимой памяти EEPROM `AT24C64`_ (или аналог) объемом 64Кбит (8 КБайт).
	English A EEPROM non-volatile memory chip `AT24C64`_ (or analog) of 64Kbit (8 KByte) is installed on the peripheral board. 120/1320 · 132 Review state Translated
1303 ../../controllers/includes/motherboards/pd76_r5_v2/eeprom_at24c64.rst:6
	Russian Назначение данной памяти - хранение аппаратной конфигурации периферийной платы или других данных пользователя (зависит от установленного программного обеспечения).
	English The purpose of this memory is to store the hardware configuration of the peripheral board or other user data (depends on the installed software). 145/1630 · 163 Review state Translated
1304 ../../controllers/includes/motherboards/pd76_r5_v2/eeprom_at24c64.rst:8
	Russian Адрес микросхемы памяти на шине I2C - ``0x56``.
	English The address of the memory chip on the I2C bus is ``0x56``. 60/490 · 49 Review state Translated
1305 ../../controllers/mcu/e1/jethub_e1_pd76_r5_ac.rst:147 • ../../controllers/mcu/e1/jethub_e1_pd76_r5_dc.rst:146
	Russian Расширители портов GPIO
	English GPIO port expanders 19/230 · 23 Review state Translated

Shortcut	Action
`?`	Open available keyboard shortcuts.
`Alt` + `Home`	Navigate to the first translation in the current search.
`Alt` + `End`	Navigate to the last translation in the current search.
`Alt` + `PageUp` or `Ctrl` + `↑` or `Alt` + `↑` or `Cmd` + `↑` or	Navigate to the previous translation in the current search.
`Alt` + `PageDown` or `Ctrl` + `↓` or `Alt` + `↓` or `Cmd` + `↓` or	Navigate to the next translation in the current search.
`Ctrl` + `Enter` or `Cmd` + `Enter`	Submit current form; this works the same as pressing Save and continue while editing translation.
`Ctrl` + `Shift` + `Enter` or `Cmd` + `Shift` +`Enter`	Unmark translation as Needing edit and submit it.
`Alt` + `Enter` or `Option` + `Enter`	Submit the string as a suggestion; this works the same as pressing Suggest while editing translation.
`Ctrl` + `E` or `Cmd` + `E`	Focus on translation editor.
`Ctrl` + `U` or `Cmd` + `U`	Focus on comment editor.
`Ctrl` + `M` or `Cmd` + `M`	Shows Automatic suggestions tab.
`Ctrl` + `1` to `Ctrl` + `9` or `Cmd` + `1` to `Cmd` + `9`	Copies placeable of a given number from source string.
`Ctrl` + `M` followed by `1` to `9` or `Cmd` + `M` followed by `1` to `9`	Copy the machine translation of a given number to current translation.
`Ctrl` + `I` followed by `1` to `9` or `Cmd` + `I` followed by `1` to `9`	Ignore one item in the list of failing checks.
`Ctrl` + `J` or `Cmd` + `J`	Shows the Nearby strings tab.
`Ctrl` + `S` or `Cmd` + `S`	Focus on search field.
`Ctrl` + `O` or `Cmd` + `O`	Copy the source string.
`Ctrl` + `Y` or `Cmd` + `Y`	Toggle the Needs editing checkbox.
`→`	Browse the next translation string.
`←`	Browse the previous translation string.