JetHome docs/Controllers — English @ Weblate

Russian

Контроллер **JetHub E1-PD76-R5-DC (v2,v3)** предназначен для управления силовой нагрузкой в системах домашней автоматизации. Содержит пять силовых реле, шесть дискретных входов "сухой контакт" и вход для подключения датчиков 1-Wire.

1347 ../../controllers/includes/motherboards/pd76_r5_v2/connectors/gpio.rst:6
	Russian UART1 TX
	English UART1 TX 8/100 · 8 Review state Translated
1348 ../../controllers/includes/motherboards/pd76_r5_v2/connectors/gpio.rst:8
	Russian UART1 RX
	English UART1 RX 8/100 · 8 Review state Translated
1349 ../../controllers/includes/motherboards/pd76_r5_v2/connectors/gpio.rst:11
	Russian 3.3В
	English 3.3В 4/100 · 4 Review state Translated
1350 ../../controllers/includes/motherboards/pd76_r5_v2/power_ac.rst:1
	Russian Предусмотрено питание от сети переменного тока:
	English Provides AC power: 18/470 · 47 Review state Translated
1351 ../../controllers/includes/motherboards/pd76_r5_v2/power_ac.rst:5
	Russian Диапазон входных напряжений переменного тока от 100В до 240В
	English AC input voltage range 100V to 240V 37/620 · 62 Review state Translated
1352 ../../controllers/includes/motherboards/pd76_r5_v2/power_ac.rst:6
	Russian Потребляемая от сети мощность не более 5Вт.
	English Power consumption from the mains is not more than 5W. 55/450 · 45 Review state Translated
1353 ../../controllers/includes/motherboards/pd76_r5_v2/power_ac.rst:8
	Russian Соблюдайте осторожность и правила монтажа устройств с питанием от сети переменного тока.
	English Use caution when installing AC-powered devices. 47/880 · 88 Review state Translated
1354 ../../controllers/mcu/e1/jethub_e1_pd76_r5_dc.rst:4
	Russian Микроконтроллер JetHub E1-PD76-R5-DC (v2,v3)
	English JetHub E1-PD76-R5-DC microcontroller (v2,v3) 44/440 · 44 Review state Translated
1355 ../../controllers/mcu/e1/jethub_e1_pd76_r5_dc.rst:15
	Russian Контроллер JetHub E1-PD76-R5-DC (v2,v3) предназначен для управления силовой нагрузкой в системах домашней автоматизации. Содержит пять силовых реле, шесть дискретных входов "сухой контакт" и вход для подключения датчиков 1-Wire.
	English The JetHub E1-PD76-R5-DC (v2,v3) controller is designed for controlling power loads in home automation systems. It contains five power relays, six digital dry contact inputs and a 1-Wire sensor input. 204/2320 · 232 Review state Translated
1356 ../../controllers/mcu/e1/jethub_e1_pd76_r5_dc.rst:69
	Russian Контроллер JetHub E1-PD76-R5-DC (v2) комплектуется процессорным модулем E1-CPU ревизии 1.2 и периферийной платой PD76-R5 ревизии 2.0.
	English The JetHub E1-PD76-R5-DC (v2) controller is equipped with an E1-CPU revision 1.2 and a PD76-R5 revision 2.0 peripheral board. 137/1450 · 145 Review state Translated
1357 ../../controllers/mcu/e1/jethub_e1_pd76_r5_dc.rst:71
	Russian Контроллер JetHub E1-PD76-R5-DC (v3) комплектуется процессорным модулем E1-CPU ревизии 1.3 и периферийной платой PD76-R5 ревизии 3.0.
	English The JetHub E1-PD76-R5-DC (v3) controller is equipped with an E1-CPU revision 1.3 and a PD76-R5 peripheral board revision 3.0. 137/1450 · 145 Review state Translated
1358 ../../controllers/mcu/e1/jethub_e1_pd76_r5_dc.rst:75
	Russian Контроллеры JetHub E1-PD76-R5-DC (v2) и JetHub E1-PD76-R5-DC (v3) функционально идентичны.
	English The JetHub E1-PD76-R5-DC (v2) and JetHub E1-PD76-R5-DC (v3) controllers are functionally identical. 107/980 · 98 Review state Translated
1359 ../../controllers/mcu/e1/jethub_e1_pd76_r5_dc.rst:77
	Russian Однако, обратите внимание, что ПО для контроллеров JetHub E1-PD76-R5-DC (v2) не будет работать на контроллерах JetHub E1-PD76-R5-DC (v3) из-за разных микросхем расширителей портов, установленных в версиях 2 и 3 данных контроллеров.
	English However, please note that software for JetHub E1-PD76-R5-DC (v2) controllers will not work on JetHub E1-PD76-R5-DC (v3) controllers due to the different port expander chips installed in versions 2 and 3 of these controllers. 240/2470 · 247 Review state Translated
1360 ../../controllers/includes/motherboards/pd76_r5_v2/power_dc.rst:16
	Russian Рекомендуемое номинальное входное напряжение питания :ref:`passive_poe` - от 12 до 48В
	English Recommended nominal input supply voltage :ref:`passive_poe` - 12 to 48V 73/880 · 88 Review state Translated
1361 ../../controllers/includes/motherboards/pd76_r5_v2/power_dc.rst:17
	Russian Полярность подключения не имеет значения. Рекомендуемая схема подачи питания: "+" источника питания на контакты 4 и 5, "-" источника питания на контакты 7 и 8 разъема Ethernet
	English The polarity does not matter. The recommended power scheme is: "+" power supply to pins 4 and 5, "-" power supply to pins 7 and 8 of the Ethernet connector 165/1850 · 185 Review state Translated
1362 ../../controllers/includes/motherboards/pd76_r5_v2/power_dc.rst:22
	Russian При одновременной подаче напряжения питания и на внешнюю клемму, и на разъем Ethernet питание будет осуществляться от источника с большим напряжением. Рекомендуется использовать один из вариантов питания.
	English If power is applied to both the external terminal and the Ethernet connector at the same time, power will be supplied from a high voltage source. It is recommended to use one of the power supply options. 205/2060 · 206 Review state Translated
1363 ../../controllers/mcu/howto/esphome/cmdline.rst:4
	Russian ESPHome - работа из командной строки
	English ESPHome - working from the command line 39/360 · 36 Review state Translated
1364 ../../controllers/mcu/software/esphome/configs/includes/ref_configs.rst:1
	Russian :ref:`Файлы конфигурации ESPHome для контроллеров JetHome JetHub <esphome_configs>`
	English :ref:`ESPHome configuration files for JetHome JetHub controllers <esphome_configs>` 83/830 · 83 Review state Translated
1365 ../../controllers/mcu/howto/esphome/cmdline.rst:9
	Russian `Оригинальная документация по установке ESPHome на Linux на сайте проекта <https://esphome.io/guides/installing_esphome.html#linux>`_
	English `The original documentation for installing ESPHome on Linux on the project website <https://esphome.io/guides/installing_esphome.html#linux>`_. 143/1330 · 133 Review state Translated
1366 ../../controllers/mcu/howto/esphome/cmdline.rst:15
	Russian Установите пакет python3-pip (если не установлен):
	English Install the python3-pip package (if not installed): 53/520 · 52 Review state Translated

Shortcut	Action
`?`	Open available keyboard shortcuts.
`Alt` + `Home`	Navigate to the first translation in the current search.
`Alt` + `End`	Navigate to the last translation in the current search.
`Alt` + `PageUp` or `Ctrl` + `↑` or `Alt` + `↑` or `Cmd` + `↑` or	Navigate to the previous translation in the current search.
`Alt` + `PageDown` or `Ctrl` + `↓` or `Alt` + `↓` or `Cmd` + `↓` or	Navigate to the next translation in the current search.
`Ctrl` + `Enter` or `Cmd` + `Enter`	Submit current form; this works the same as pressing Save and continue while editing translation.
`Ctrl` + `Shift` + `Enter` or `Cmd` + `Shift` +`Enter`	Unmark translation as Needing edit and submit it.
`Alt` + `Enter` or `Option` + `Enter`	Submit the string as a suggestion; this works the same as pressing Suggest while editing translation.
`Ctrl` + `E` or `Cmd` + `E`	Focus on translation editor.
`Ctrl` + `U` or `Cmd` + `U`	Focus on comment editor.
`Ctrl` + `M` or `Cmd` + `M`	Shows Automatic suggestions tab.
`Ctrl` + `1` to `Ctrl` + `9` or `Cmd` + `1` to `Cmd` + `9`	Copies placeable of a given number from source string.
`Ctrl` + `M` followed by `1` to `9` or `Cmd` + `M` followed by `1` to `9`	Copy the machine translation of a given number to current translation.
`Ctrl` + `I` followed by `1` to `9` or `Cmd` + `I` followed by `1` to `9`	Ignore one item in the list of failing checks.
`Ctrl` + `J` or `Cmd` + `J`	Shows the Nearby strings tab.
`Ctrl` + `S` or `Cmd` + `S`	Focus on search field.
`Ctrl` + `O` or `Cmd` + `O`	Copy the source string.
`Ctrl` + `Y` or `Cmd` + `Y`	Toggle the Needs editing checkbox.
`→`	Browse the next translation string.
`←`	Browse the previous translation string.